This kit provides adapter boards that enable the Flyswatter to interface with the BeagleBoard's JTAG and RS-232 headers.  This adapter works with the following boards:

• BeagleBoard (original B/C versions)
• BeagleBoard-xM
• PandaBoard

Features:

• JTAG Adapter Board - This board plugs into the Flyswatter's 14-pin ARM JTAG connector and converts the pins to a 14-pin header that is compatible with the BeagleBoard's 14-pin JTAG interface (TI Interface). The Adapter board uses the 14-pin JTAG cable that comes with the Flyswatter.
• RS-232 Adapter Board -  This board plugs into the Flyswatter's RS-232 connector and converts the serial port pins into a 10-pin header that is compatible with the BeagleBoard's 10-pin RS-232 interface.
• 10-pin Ribbon Cable -  This cable is used to connect to the BeagleBoard's 10-pin RS-232 interface to the Flyswatter.  Cable length = 8 inches.
  
• Open hardware – complete schematics provided
• Package Includes: JTAG adapter board, RS-232 adapter board, 10-pin RS-232 ribbon cable

• BeagleBoard JTAG adapter board schematic
• BeagleBoard RS-232 adapter board schematic
• Quick start instructions
• BeagleBoard JTAG information
• BeagleBoard OpenOCD information
• Debugging on the Cortex - A8 (by Magnus Lundin)
• Simple standalone LED blink test program (by Magnus Lundin)

Note:  The BeagleBoard Adapter Kit only works with the Flyswatter.  If you want a BeagleBoard JTAG kit for the Flyswatter2, use the ARM20TI14 JTAG adapter instead.

OpenOCD version 0.4 now fully supports the BeagleBoard, BeagleBoard-xM, and the PandaBoard.